All content on EnviroDIY is licensed as Creative Commons Attribution-ShareAlike 4.0. Hardware designs on EnviroDIY are released under the CERN Open Hardware License 1.2. Alternative licenses are available. Learn more
Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water. New to EnviroDIY? Start here
Learn DIY Electronics for Environmental Monitoring
- When: May 20 and 21, from 8:30 a.m. to 5 p.m.
- Where: Stroud Water Research Center, 970 Spencer Road, Avondale, PA 19311
- Audience: Beginners and those with intermediate experience programming data loggers and using environmental monitoring equipment. State and federal agency staff; academic faculty; high school, undergraduate, and graduate students; and researchers from environmental NGOs and watershed organizations have attended previous workshops.
- Cost: $135 per person. Registration is limited to 24.
Community Activity See all activity
nick replied to the topic Continous HAB monitoring in the forum Mayfly Data Logger 1 months, 2 weeks ago
We have been testing out the Turner C-FLUOR (PC) PHYCOCYANIN sensor and getting mixed results where we are not sure if it is the sensor, sketch, or something else.
When measuring pure di water we are getting readings of around 5 – 6 ppb in both an opaque jar and open jar with the sensor in a shade cap.
We bought blue spirulina (…[Read more]
Bob Blumenscheid replied to the topic New Xbee Modem: XB3-C-GM1-UT-001 in the forum Mayfly Data Logger 1 months, 2 weeks ago
Hello Shannon,
I am with Digi International – I wanted to check in to see if you were able to get our new XBee modules working on the Mayfly. If you need more information, I can connect you with Tech Support or an FAE who can provide any information you need.
We’re excited to see this XBee application, and we appreciate you working with our products!
Bob Blumenscheid became a registered member 1 months, 2 weeks ago
Bob Blumenscheid
@bblumenscheid
Ryan NoCO started the topic Replace logger cable with LoRa? in the forum Infrastructure and Equipment 1 months, 2 weeks ago
Hi, I’m curious if there are any plans to replace the data cable from sensor to the MayFly with LoRa wireless technology or to make it an option? LoRa (Long Range) is a wireless communication technology, specifically a physical (PHY) layer protocol, designed for long-range, low-power, and low-data-rate communications, primarily used in Internet of…[Read more]
Ryan NoCO became a registered member 1 months, 2 weeks ago
Ryan NoCO
@ryguynoco
Shannon Hicks replied to the topic Pelican 1120 drilling template in the forum Mayfly Data Logger 1 months, 2 weeks ago
I haven’t seen any other templates besides the one you linked. I never use them myself, I just lay them out in whatever pattern is the easiest, based on the sizes of the cable glands. I prefer to stagger them as shown in this photo from the kit’s shop page, since that makes it easier to get your hand around the end part to tighten them. I us…[Read more]
Mississippi Watershed Management Organization became a registered member 1 months, 2 weeks ago
Mississippi Watershed Management Organization
@mwmo
nick started the topic Pelican 1120 drilling template in the forum Mayfly Data Logger 1 months, 2 weeks ago
Can someone direct me to a 4 hole drilling template if it exist?
I found this: https://github.com/EnviroDIY/EnviroDIY_Mayfly_Logger/blob/master/hardware/1120Pelican_enviroDIY_5.pdf
I thought I found and bookmarked a 3 hole version before, but now I can’t seem to locate it.
Thank You
Shannon Hicks replied to the topic External circuit protection limt in the forum Mayfly Data Logger 1 months, 2 weeks ago
Are you referring to an EnviroDIY Monitoring Station kit which contains a Mayfly Data Logger, or is your station based on some other type of controller? And are talking about limiting the amount of current your monitoring kit could draw from a power source, or are you talking about limiting the output current of the kit in regards to the load…[Read more]
Dr.Wu started the topic External circuit protection limt in the forum Mayfly Data Logger 1 months, 3 weeks ago
We are looking at adding an external circuit breaker to protect a monitoring kit. We are configuring a monitoring kit to be a mobile or portable unit, that can be carried aboard a ship/boat of opportunity. Often in the field on a boat or in some weather, equipment gets wet.
What level of current should an external breaker be rated to prevent…[Read more]