Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water.
New to EnviroDIY? Start here

Reply To: Bringing in serial data through UART on 20-Pin connector

Home › Forums › Mayfly Data Logger › Bringing in serial data through UART on 20-Pin connector › Reply To: Bringing in serial data through UART on 20-Pin connector

2020-06-11 at 2:25 PM #14191
Kurt Rosenberger
Participant

    Hi Shannon and Sara

    Thank you for your replies – yes, I was not able to communicate with the Mayfly while I had data coming in, so I will switch to RX1/TX1. However, I’m still not clear on how to designate that in the initial setup in the sketch. It was fine with A6 and A7, but when I try to use A8/A9 or RX1/TX1 in the ‘static const’ declaration, it won’t compile. Attached is the example sketch I’m using. Thanks again for your help

    Attachments:
    1. KitchenSink.ino