Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water.
New to EnviroDIY? Start here

Reply To: Setting the real time clock

Home › Forums › Mayfly Data Logger › Setting the real time clock › Reply To: Setting the real time clock

2017-04-22 at 9:21 PM #2163
Matt Findley
Participant

    Thanks for the response. I had not tried the PCsync.exe yet, I was taking small steps and had only sent a “T149290XXXX” string manually over the Arduino IDE serial monitor before posting to the forum.

    Since then, I set and read the time successfully using the adjust.ino sketch that was suggested by S. Hicks and then also read the time using the now.ino example code.

    After some fiddling, here’s what I’ve concluded: PCSynch.ino is setting and reading the time correctly off the RTC (and so is the helper program PCsynch.exe), but there were some bugs in the serial.print commands in the loop() section of the PCSynch.ino sketch. How do I go about correcting the github code? … think it is called a “pull request” in their parlance, but am otherwise unclear on how to proceed.

    It is really tiny stuff: using double quotes for a multi-character string instead of single quotes and removing a – 1 operation from the end of a now.dayOfWeek() call.