Forum Replies Created
-
AuthorPosts
-
@shicks Its working now. Thank you. But the issue is with the b_address_change sketch. This is the output.
113:12:30.112 -> ��fx������~��<code>���x�f~������怘�</code>f�f�f�f~~�ffx����憆���������f�~fxf���~����fx�������~f�<code>�x��������怘��f����f���~��x</code>��fx�����������f~f�fx怘�������f<code></code>f���ff��fx��xx��fx���<code>���x���fx�������~��xfx��~��x</code>��fx���怘�f��<code>fx�f�~��x</code>��fx����怘@shicks When I try the “b_address_change” its giving some gibberish output. What could be the reason?
113:12:30.112 -> ��fx������~��<code>���x�f~������怘�</code>f�f�f�f~~�ffx����憆���������f�~fxf���~����fx�������~f�<code>�x��������怘��f����f���~��x</code>��fx�����������f~f�fx怘�������f<code></code>f���ff��fx��xx��fx���<code>���x���fx�������~��xfx��~��x</code>��fx���怘�f��<code>fx�f�~��x</code>��fx����怘@shicks I had a doubt related to the baud rate mentioned in the example sketches which is “115200” but for SDI-12 configuration of TEROS 12 its “1200”. Should I change it? Also if I change the address of the sensor will I be able to obtain data from the data logger provided by METER or do I have to set it to “0” each & every time I have to access the data logger?
@shicks For now I want to connect one Teros 12 but in future want to connect four. Also I have both Mega & Nano with me. The output is an audio jack for which I have bought a trs 3.5mm breakout board. I just want to display the sensor data on my computer & use a esp module to display it on some website for future purposes
-
AuthorPosts