Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water.
New to EnviroDIY? Start here

dan@wachusett

Forum Replies Created

Viewing 31 post (of 31 total)
1 2 3 4
  • Author
    Posts
  • 2019-08-14 at 9:46 AM in reply to: SDI-12 Change Address for Meter Hydros 21 CTD Sensor #13070
    dan@wachusett
    Participant

      Update…
      After some searching on other forums it seems the sketch upload error is just a communications error. Is there any reason why I have previously been able to upload sketches to my board and send output to the serial monitor, but now I cannot? Could it be a driver issue?

      I did not install the FTDI virtual COM port (VCP) driver because when I first connected the Mayfly to my PC it was recognized… my IT dept said that I already had the necessary driver installed. Perhaps this is not the case?

    • Author
      Posts
    Viewing 31 post (of 31 total)
    1 2 3 4