Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water.
New to EnviroDIY? Start here

ehazard

  • Profile picture of ehazard

    ehazard started the topic Changing I2C address of RTC in the forum Mayfly Data Logger 5 years ago

    Hello. I’m currently working on trying to take measurements from a CO2 sensor (k30) using my Mayfly data logger (version 0.5b). The sensor is an analog and I’m using the I2C port connected to the SDA and SCL pins on the Mayfly.

    The sensor comes preprogrammed with the hexadecimal address 0x68. After quite a bit of testing to attempt to get the…[Read more]

  • Profile picture of ehazard

    ehazard replied to the topic Mayfly SCL and SDA voltage level in the forum Mayfly Data Logger 5 years ago

    Hello. I’m currently trying to get a sensor working using I2c protocol, and I have a question about the 2.2 kohm resistors on the SDA and SCL lines. Are those resistances automatically enabled, or is there a line of code that would enable them? Otherwise, if the pull-up resistors are automatically enabled on the Mayfly, is there any way to disable…[Read more]

  • Profile picture of ehazard

    ehazard replied to the topic XBee Networks of Mayfly Loggers – 900Mhz in the forum Mayfly Data Logger 6 years ago

    Hi Everyone,

    I’m working with @dartmouthwsn, the original poster on this thread, to construct a logger network using Mayflys and 900 Mhz XBee Pros. We had the code successfully working so that the logger Mayflys were able to send data to a centrally located node using the Xbee Pros. The code has been functional for several months and was tested a…[Read more]

  • Profile picture of ehazard

    ehazard became a registered member 6 years ago