Michael Daniel – EnviroDIY

Michael Daniel replied to the topic Atlas Scientific Dissolved Oxygen Sensor Not Reading in the forum Environmental Sensors 9 months ago

I have both a pH and a DO sensor working on one of my data loggers., and I’ve had up to four Atlas Scientific sensors working at once using a sensor bridge: https://atlas-scientific.com/carrier-boards/sensor-bridge/ I currently have the sensors connected through the qwiic ports, and they seem to be working fine. Here’s my code, there’s a lot of…[Read more]
Michael Daniel replied to the topic Need Help with Clarivue10 Turbidity Sensors in the forum Environmental Sensors 1 years, 9 months ago

Thank you so much for all your help and hard work! Everything is working perfectly now.
Michael Daniel replied to the topic Need Help with Clarivue10 Turbidity Sensors in the forum Environmental Sensors 1 years, 10 months ago

The Mayfly is at least v1.1, but I’m unsure what revision it is. Would it say RevB on the board somewhere?

Also, I should’ve mentioned earlier that I’ve tried to run the address change program when the turbidity sensor wasn’t working and the program couldn’t find the sensor at all, regardless of the amount of times I let it loop through the…[Read more]
Michael Daniel started the topic Need Help with Clarivue10 Turbidity Sensors in the forum Environmental Sensors 1 years, 10 months ago

Hello everyone,

I’m having a very similar problem to what James had been experiencing in this forum post. I’ve recently installed 3 Clarivue10 Turbidity sensors in stream, but only one of them (LYHWR005) works reliably. The other two (LYHWR004 and LYHWR006) typically only work for several hours a day.

I believe the problem is related to the…[Read more]
Michael Daniel replied to the topic Data Uploading but not Publishing in the forum Mayfly Data Logger 2 years, 9 months ago
I decided to try to make a new site in order to try to work around the problem, but that hasn’t seemed to work either. I’m now getting 504 response codes. The data is still uploading to MMW but not publishing. I have to be missing something obvious, right? The new site is NTNWD in the same spot.
```
/**…
```
[Read more]
Michael Daniel replied to the topic Data Uploading but not Publishing in the forum Mayfly Data Logger 2 years, 10 months ago

Thanks for replying so quickly Jim!

I have another station with the underscore that is currently uploading correctly, but I’ll give it a shot.
Michael Daniel started the topic Data Uploading but not Publishing in the forum Mayfly Data Logger 2 years, 10 months ago

Hello all,

Forgive me if this has been discussed before, I searched the forums and I wasn’t able to find any similar issues.

I’ve been trying to set up a new monitoring station (Tom_Nat) and I’m running into a strange problem. It seems as though data from the data logger is being uploaded to MMW, but the data isn’t being published correctly. The…[Read more]
Michael Daniel wrote a new post 3 years, 3 months ago

Nancy Lilly (@lyh2o) is the stormwater outreach coordinator for Lynchburg Water Resources in Lynchburg, Virginia.

By now, we’re all tired of virtual meetings and endless Zoom calls. However, there are some Z […]
Michael Daniel replied to the topic Battery Failing In the middle of the night in the forum Mayfly Data Logger 3 years, 3 months ago

The battery was not replaced again on August 25th, that is the same battery that will no longer charge. Doesn’t the scale of battery loss and gain look extreme. I adjusted the solar panel to get more light, it is in a pretty shady area but it get direct sunlight for a couple of hours everyday.

Do you all think I need a bigger battery or a l…[Read more]
Michael Daniel started the topic Battery Failing In the middle of the night in the forum Mayfly Data Logger 3 years, 3 months ago

Hello,

I’ve been having a problem with one of my stations where the battery will fail for a couple of hours sometimes. I can’t determine if there is a pattern, for example its been cloudy for a few days but that didn’t have any effect on the battery lasting through the night yesterday. I have replaced the battery once and will do it again t…[Read more]
Michael Daniel replied to the topic PlatformIO error with MS 0.28.01 in the forum Mayfly Data Logger 3 years, 9 months ago

That worked! Thanks Shannon!
Michael Daniel replied to the topic PlatformIO error with MS 0.28.01 in the forum Mayfly Data Logger 3 years, 9 months ago

Thanks for the suggestion Matt,

It didn’t work very well, here’s the new error message:

Arduino: 1.8.13 (Windows Store 1.8.42.0) (Windows 10), Board: “Arduino Uno”

Sketch uses 6206 bytes (19%) of program storage space. Maximum is 32256 bytes.
Global variables use 631 bytes (30%) of dynamic memory, leaving 1417 bytes for local variables. Maximum…[Read more]
Michael Daniel replied to the topic PlatformIO error with MS 0.28.01 in the forum Mayfly Data Logger 3 years, 9 months ago

Hi all,
I’m new to all this so still using ArduinoIDE for now. I’m getting a similar error when trying to change the address for a Meters CDT sensor. (One of the ones I recently purchased was recalled so I am trying to connect a different one).

The error reads “Invalid version ‘0.28.01’ for library in: C…[Read more]
Michael Daniel became a registered member 4 years, 5 months ago

@lyh2o