Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of 
@scornia
Active 4 years, 1 months ago-
scornia replied to the topic Logging Mayfly with Decagon SDI-12 Sensor in the forum Mayfly Data Logger 4 years, 4 months ago
It looks like they are all there. Here is a better photo from a different angle.
-
scornia replied to the topic Logging Mayfly with Decagon SDI-12 Sensor in the forum Mayfly Data Logger 4 years, 4 months ago
Sure, no problem. I didn’t make any changes to the change address sketch. The Here is what I am looking at:
-
scornia replied to the topic Logging Mayfly with Decagon SDI-12 Sensor in the forum Mayfly Data Logger 4 years, 4 months ago
Our wiring looks to be correct. We talked with the folks at Meter and they had us test the voltage across the board which seemed fine. They are sending us an independent tester to see if it is an issue with the sensor itself.
-
scornia replied to the topic Logging Mayfly with Decagon SDI-12 Sensor in the forum Mayfly Data Logger 4 years, 4 months ago
Hi Sara,
I am having issues when I come to this step and can use a little help troubleshooting my issue. I cannot get my sensor to connect to an address. I have an SDI-12 sensor with bare wires connected to grove 4-pin terminal adapter set up just as you explained in the instructions. All of the connections seem secure, but when I run the…[Read more]
-
scornia became a registered member 4 years, 10 months ago
scornia,
In May I had this exact setup deployed and working. I used a WiFi modem and was logging to MMW. It slowly lost power because it was in too much shade and eventually I replaced it with a U-20 level logger. Now I’m working on this setup again and I’m having a similar issue to yours; the address change sketch just loops and my serial monitor…[Read more]