Welcome to EnviroDIY, a community for do-it-yourself environmental science and monitoring. EnviroDIY is part of WikiWatershed, an initiative of Stroud Water Research Center designed to help people advance knowledge and stewardship of fresh water.
New to EnviroDIY? Start here

Jim Moore

Forum Replies Created

Viewing 3 posts - 101 through 103 (of 103 total)
1 2 3 … 9 10 11
  • Author
    Posts
  • 2016-06-21 at 6:02 PM in reply to: Atlas Scientific EZO sensors #1578
    Jim Moore
    Participant

      I have test code from atlas scientific that works.

      What changes do I need to use the mayfly board other than changing the board type in the IDE?

      2016-06-16 at 10:55 PM in reply to: Atlas Scientific EZO sensors #1567
      Jim Moore
      Participant

        Thanks Steve.

        That works but I noticed the 5V pins were at 3.27 Volts and the 3.3V pins were at 3.32 Volts. Is there another pin to turn on the 5V boost ckt?

        2016-06-10 at 9:31 PM in reply to: Mayfly USB Connection Problems #1558
        Jim Moore
        Participant

          I received my starter kit a few days ago and could not connect to computer (surfacw-win 10) although my system worked fine with an arduino uno on another project.

          The cable that came with the kit was apparently defective because the system worked fine when I used another usb/microUSB cable I had. The defective cable supplied power but no serial comm

          Has anybody else had similiar problems with the supplied cable? If so, may be a quality problem with the supplier of that cable.

        • Author
          Posts
        Viewing 3 posts - 101 through 103 (of 103 total)
        1 2 3 … 9 10 11